 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| AWT6134 KPCS/CDMA 3.4V/28dBm Linear Power Amplifier Module PRELIMINARY DATA SHEET - Rev 1.0 FEATURES * * * * * * * * * InGaP HBT Technology High Efficiency: 39% Low Quiescent Current: 48 mA Low Leakage Current in Shutdown Mode: <1 A VREF = +2.8 V (+2.7 V min over temp) Optimized for a 50 System Low Profile Miniature Surface Mount Package: 1.56mm Max CDMA 1XRTT Compliant CDMA 1xEV-DO Compliant APPLICATIONS * Korean PCS CDMA Wireless Handsets M7 Package 10 Pin 4mm x 4mm Surface Mount Module PRODUCT DESCRIPTION The AWT6134 meets the increasing demands for higher efficiency and linearity in CDMA 1XRTT handsets. The PA module is optimized for VREF = +2.8 V, a requirement for compatibility with the Qualcomm 6000 chipset. The device is manufactured on an advanced InGaP HBT MMIC technology offering state-of-the-art reliability, temperature stability, and ruggedness. Selectable bias modes that optimize efficiency for different output power levels, and a shutdown mode with low leakage current, increase handset talk and standby time. The self-contained 4mm x 4mm surface mount package incorporates matching networks optimized for output power, efficiency, and linearity in a 50 system. GND at slug (pad) VCC RFIN GND 1 2 3 Bias Control 10 VCC 9 8 7 6 GND RFOUT GND GND VMODE 4 VREF 5 Figure 1: Block Diagram 07/2003 AWT6134 GND VCC RFIN GND VMODE VREF 1 2 3 4 5 GND 10 VCC 9 8 7 6 GND RFOUT GND GND Figure 2: Pinout (X-ray Top View) Table 1: Pin Description PIN 1 2 3 4 5 6 7 8 9 10 NAME V CC RFIN GND VMODE VREF GND GND RFOUT GND V CC DESCRIPTION Supply Voltage RF Input Ground Mode Control Voltage Reference Voltage Ground Ground RF Output Ground Supply Voltage 2 PRELIMINARY DATA SHEET - Rev 1.0 07/2003 AWT6134 ELECTRICAL CHARACTERISTICS Table 2: Absolute Minimum and Maximum Ratings PARAMETER Supply Voltage (VCC) Mode Control Voltage (VMODE) Reference Voltage (VREF) RF Input Power (PIN) Storage Temperature (TSTG) MIN 0 0 0 -40 MAX +5 +3.5 +3.5 +10 +150 UNIT V V V dB m C Stresses in excess of the absolute ratings may cause permanent damage. Functional operation is not implied under these conditions. Exposure to absolute ratings for extended periods of time may adversely affect reliability. Table 3: Operating Ranges PARAMETER Operating Frequency (f) Supply Voltage (VCC) Reference Voltage (VREF) Mode Control Voltage (VMODE) RF Output Power (POUT) Case Temperature (TC) MIN 1750 +3.2 +2.7 0 +2.5 0 +27.5(1) -30 TYP +3.4 +2.8 +2.8 +28.0 - MAX 1780 +4.2 +3.1 +0.5 +3.1 +0.5 +85 UNIT MHz V V V dB m C COMMENTS PA "on" PA "shut down" Low Bias Mode High Bias Mode The device may be operated safely over these conditions; however, parametric performance is guaranteed only over the conditions defined in the electrical specifications. Notes: (1) For operation at TC = +85 C and VCC = +3.2 V, POUT is derated by 0.5 dB. PRELIMINARY DATA SHEET - Rev 1.0 07/2003 3 AWT6134 Table 4: Electrical Specifications (TC = +25 C, VCC = +3.4 V, VREF = +2.8 V, 50 system) PARAMETER Gain Adjacent Channel Power (1) at 1.25 kHz offset Primary Channel BW = 1.23 MHz Adjacent Channel BW = 30 kHz Adjacent Channel Power (1) at 2.25 MHz offset Primary Channel BW = 1.23 MHz Adjacent Channel BW = 30 kHz Power-Added Efficiency (1) Quiescent Current (Icq) Reference Current Mode Control Current Leakage Current Noise in Receive Band 1840 MHz to 1870 MHz Harmonics 2fo 3fo, 4fo Input Impedance MIN 24 21 TYP 26 23.5 MAX 29 27 UNIT dB COMMENTS POUT = +28 dBm, VMODE = 0 V POUT = +16 dBm, VMODE = +2.8 V - -49 -52 -46.5 -46.5 dB c POUT = +28 dBm, VMODE = 0 V POUT = +16 dBm, VMODE = +2.8 V 37 8 - -60 -68 39 9 48 3.5 0.3 <1 -137 -141 -45 -55 - -57 -57 60 5 0.5 5 -135 -138 -30 -30 2:1 dB c % mA mA mA A dBm/Hz POUT = +28 dBm, VMODE = 0 V POUT = +16 dBm, VMODE = +2.8 V POUT = +28 dBm, VMODE = 0 V POUT = +16 dBm, VMODE = +2.8 V VMODE = +2.8 V through VREF pin, PA "on" through VMODE pin, VMODE = +2.8 V VCC = +4.2 V, VREF = 0 V VMODE = 0 V POUT = +28 dBm, VMODE = 0 V POUT = +16 dBm, VMODE = +2.8 V POUT < +28 dBm dB c VSWR Spurious Output Level (all spurious outputs) - - -65 dB c POUT < +28 dBm In-band load VSWR < 8:1 Out-of-band load VSWR < 8:1 Applies over all voltage and temperature operating ranges VCC = +5.0 V, PIN = +5 dBm Applies over full operating temperature range Load mismatch stress with no permanent degradation or failure 8:1 - - VSWR Notes: (1) ACPR and PAE limits apply to middle frequency only. 4 PRELIMINARY DATA SHEET - Rev 1.0 07/2003 AWT6134 Table 5: Electrical Specifications (TC = +25 C, VCC = +3.4 V, VREF = +2.9 V, VMODE = +2.9 V, 50 system) PARAMETER Gain Adjacent Channel Power (1) at 1.25 kHz offset Primary Channel BW = 1.23 MHz Adjacent Channel BW = 30 kHz Adjacent Channel Power (1) at 2.25 MHz offset Primary Channel BW = 1.23 MHz Adjacent Channel BW = 30 kHz Power-Added Efficiency (1) Quiescent Current (Icq) Reference Current Mode Control Current Leakage Current Noise in Receive Band 1840 MHz to 1870 MHz Harmonics 2fo 3fo, 4fo Input Impedance MIN 23.5 20 TYP 25 23.5 -50 -52 MAX 28 27 -46.5 -46.5 UNIT dB COMMENTS POUT = +28 dBm POUT = +16 dBm POUT = +28 dBm POUT = +16 dBm dB c 37 8 - -58 -68 40 9 56 3.5 0.3 <1 -135 -56 -57 68 5 0.5 5 -133 dB c POUT = +28 dBm POUT = +16 dBm POUT = +28 dBm POUT = +16 dBm VREF = +2.9 V through VREF pin, PA "on" through VMODE pin VCC = +4.2 V, VREF = 0 V VMODE = 0 V % mA mA mA A dBm/Hz POUT = +28 dBm, VMODE = +2.8 V - -45 -55 - -30 -30 2:1 dB c VSWR POUT < +28 dBm In-band load VSWR < 8:1 Out-of-band load VSWR < 8:1 Applies over all voltage and temperature operating ranges VCC = +5.0 V, PIN = +5 dBm Applies over full operating temperature range Spurious Output Level (all spurious outputs) - - -65 dB c Load mismatch stress with no permanent degradation or failure 8:1 - - VSWR Notes: (1) ACPR and PAE limits apply to middle frequency only. PRELIMINARY DATA SHEET - Rev 1.0 07/2003 5 AWT6134 APPLICATION INFORMATION To ensure proper performance, refer to all related Application Notes on the ANADIGICS web site: http://www.anadigics.com Shutdown Mode The power amplifier may be placed in a shutdown mode by applying logic low levels (see Operating Ranges table) to both the VREF and VMODE voltages. Bias Modes The power amplifier may be placed in either a Low Bias mode or a High Bias mode by applying the appropriate logic level (see Operating Ranges table) to the VMODE voltage. The Bias Control table lists the recommended modes of operation for various applications. Table 6: Bias Control APPLICATION CDMA - low power CDMA - high power Shutdown POUT LE V E LS <+16dBm >+16 dBm - BIAS MODE Low High Shutdown V R EF +2.8 V +2.8 V 0V VMODE +2.8 V 0V 0V VCC1 VCC2 C1 0.01F 1 C3 0.01F VCC RFIN GND VMODE VREF VCC GND RFOUT GND GND GND at slug 10 9 8 7 6 2 3 C4 2.2F ceramic RF IN RF OUT VMODE VREF 4 5 C2 0.01F Figure 3: Application Circuit Schematic 6 PRELIMINARY DATA SHEET - Rev 1.0 07/2003 AWT6134 PACKAGE OUTLINE Figure 4: M7 Package Outline - 10 Pin 4mm x 4mm Surface Mount Module AWT6134 AWT6134 BBB LASER MARKED Figure 5: Branding Specification PRELIMINARY DATA SHEET - Rev 1.0 07/2003 7 AWT6134 COMPONENT PACKAGING Figure 6: Tape & Reel Packaging Table 7: Tape & Reel Dimensions PACKAGE TYPE 4mm X 4mm TAPE WIDTH 12mm POCKET PITCH 8mm REEL CAPACITY 2500 MAX REEL DIA 13" 8 PRELIMINARY DATA SHEET - Rev 1.0 07/2003 AWT6134 NOTES PRELIMINARY DATA SHEET - Rev 1.0 07/2003 9 AWT6134 NOTES 10 PRELIMINARY DATA SHEET - Rev 1.0 07/2003 AWT6134 NOTES PRELIMINARY DATA SHEET - Rev 1.0 07/2003 11 AWT6134 ORDERING INFORMATION ORDER NUMBER TEMPERATURE RANGE -30 oC to +110 oC PACKAGE DESCRIPTION 10 Pin 4mm x 4mm Surface Mount Module COMPONENT PACKAGING AWT6134M7P8 Tape and Reel, 2500 pieces per Reel ANADIGICS, Inc. 141 Mount Bethel Road Warren, New Jersey 07059, U.S.A. Tel: +1 (908) 668-5000 Fax: +1 (908) 668-5132 URL: http://www.anadigics.com E-mail: Mktg@anadigics.com IMPORTANT NOTICE ANADIGICS, Inc. reserves the right to make changes to its products or to discontinue any product at any time without notice. The product specifications contained in Advanced Product Information sheets and Preliminary Data Sheets are subject to change prior to a product's formal introduction. Information in Data Sheets have been carefully checked and are assumed to be reliable; however, ANADIGICS assumes no responsibilities for inaccuracies. ANADIGICS strongly urges customers to verify that the information they are using is current before placing orders. WARNING ANADIGICS products are not intended for use in life support appliances, devices or systems. Use of an ANADIGICS product in any such application without written consent is prohibited. 12 PRELIMINARY DATA SHEET - Rev 1.0 07/2003 |
Price & Availability of AWT6134
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |